Vest 3 User Manual
YOUR WOOJER VEST
1 Control unit
2 Front-left transducer
3 Front-right transducer
4 Side-left transducer
5 Side-right transducer
6 Back-left transducer
7 Back-right transducer
8 Charging port
9 Chair/hanging notch
10 Power/Bluetooth button
11 Power/Audio source indicator
12 Volume Up button
13 Volume Down button
14 Volume indicator
15 Sensation Up button
16 Sensation Down button
17 Haptic indicator
18 Bluetooth Headphones indicator
19 Bluetooth Source indicator
20 Battery level / charging indicator
21 Multi-channel input indicator
22 Analog audio-in port
23 Digital USB-C input port24 Wired headphone jack
FIRST TIME USAGE
CHARGE YOUR VEST
Connect the provided 20V USB-C Power Delivery charger to the rear charging port.
Do not use the front USB-C port for charging!
Do not use a standard mobile charger!
Install Woojer app to control your Woojer, pair it with other devices, update its firmware, fine-tune your experience and much more. it’s highly recommended to install Woojer app on your mobile. woojer.com/woojerapp
UPDATE THE FIRMWARE
To get the most out of your Vest, make sure you're using the latest available firmware.
Launch Woojer app to update the firmware.
CONNECT YOUR VEST
CONNECT YOUR HEADPHONES
If you’re using wired headphones,
connect them to the headphone jack
3 seconds long-press on the power button - Vest is ON/OFF
WEAR YOUR VEST
All adjusting straps must be loosened before wearing the Vest. Make sure to follow these steps in order.
1. Close and tighten the waist straps.
2. Close and tighten the chest strap.
3. Pull both shoulder straps in parallel to ensure tight contact of all haptic units to the body.
ATTACHING THE VEST TO A CHAIR
Attach the Vest to a chair using Woojer Chair Adapter.
FINE TUNE YOUR EXPERIENCE
1. Volume Up button
2. Volume Down button
3. Sensation Up button
4. Sensation Down button
To optimize audio-haptic sync:
launch Woojer app
MANUAL BLUETOOTH PAIRING
PAIR WITH A BLUETOOTH AUDIO SOURCE
Press and hold the Power button for 5 seconds.
Bluetooth Source indicator will blink rapidly with red and blue.
On your source device, enter Bluetooth screen, locate “Woojer Vest 3” and pair with it.
PAIR WITH BLUETOOTH HEADPHONES
Press and hold the power button AND the Volume Up button for 5 seconds together.
Bluetooth headphones indicator will blink rapidly with red and blue.
Set your Bluetooth headphones into pairing mode and place them within proximity to the Vest.Both devices should be paired within 30 seconds.
Vest is on
Audio source connected
Slow blinking blue:
Searching for known Bluetooth devices
Alternating red/blue blinking:
Bluetooth audio source pairing mode
Bluetooth audio source connected
Alternating red/blue blinking:
Bluetooth headphones pairing mode
Bluetooth headphones connected
Solid green: Battery 81%-100%S
Solid yellow: Battery 21%-80%
Solid red: Battery 5%-20%
Slow red blinking: Battery 0%-4%
Pulsating red: charging 0%-20%
Pulsating yellow: charging 21%-80%
Pulsating green: charging 81%-99%
Solid green: charging complete
Multi-channel source detected
Battery: 4SP Li-On battery pack 14.4V
Charging port: USB-C Power Delivery
Charging Voltage: 20V only.
Charging Time: 3h
Haptic Freq Response: 1-250Hz.
Audio Freq Response: 20-20KHz
Transducer: 6XOsci V2 TRX
Transducer Impedance: 11Ω
Audio Output: Aux 3.5mm TRRS, BT Audio A2DP
Audio Input: Aux 3.5mm TRRS, USB-Stereo Audio, BT Audio A2DP
Bluetooth: Bluetooth 5.0 Audio, BLE App Control and Update
Headphones Amp THD: 1%, f = 1 kHz
Headphones Out S/N Ratio: 98 dB
Headphones Amplifier Output: 138mW
CARE AND MAINTENANCE
•Keep the Woojer Vest Series 3 and accessories device dry.
Precipitation, humidity, and all types of liquids or moisture can contain minerals that will corrode electronic circuits.
•Do not store the device in hot areas. High temperatures can shorten the life of electronic devices, damage batteries, and warp or melt certain plastics.
•Do not store the device in cold areas. When the device returns to its normal temperature, moisture can form inside the device and damage electronic circuit boards.
•Do not attempt to open the device.
•Do not drop. Rough handling can break internal circuit boards and fine mechanics.
•Do not use harsh chemicals, cleaning solvents, or strong detergents to clean the device.
•If the device doesn’t work properly, please contact our technical support team through our website, at www.woojer.com/support
SAFETY AND WARNINGS (READ CAREFULLY BEFORE USE)
•This product contains a rechargeable Lithium-ion battery and should not be disposed together with household waste. This product must be discarded in accordance with your local legal requirements.
•As with other devices with permanent magnets, Woojer Vest Series 3 is not suitable for use by persons with pacemakers.
•Do not use Woojer Vest Series 3 with headphones/earphones while driving, cycling, or operating any motorized vehicle. This may create a traffic hazard and may be illegal.
•It can be dangerous to play your music with headphones/earphones at high volume while walking or engaged in other activities. Exercise extreme caution and discontinue use in potentially hazardous situations.
•Avoid using headphones/earphones at high volume. Hearing experts advise against continuous loud and extended music play. Keep the volume at a moderate level, so that you are better able to hear outside sound.
•If Woojer Vest Series 3 overheats excessively during use, do not use it and contact our technical support team through www.woojer.com/support
•Avoid charging your Woojer Vest Series 3 at extremely high or low temperatures.
DECLARATION OF CONFORMITY, CERTIFICATES,AND SAFETY PROTOCOLS
Federal communications commission notice this device complies with part 15 of the FCC rules.
Operation is subject to the following two conditions:
(1) this device may not cause harmful interference, and(2) this device must accept any interference received, including interference that may cause undesired operation.
Any Changes or modifications not expressly approved by the party responsible for compliance could void the user’s authority to operate the equipment.
This equipment has been tested and found to comply with the limits for a class b digital device, pursuant to part 15 of the FCC rules.
These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates uses and can radiate radio frequency energy and, if not installed and used in accordance with the instructions, may cause harmful interference to radio communications.
However, there is no guarantee that interference will not occur in a particular installation if this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
- reorient or relocate the receiving antenna.
- increase the separation between the equipment and receiver.
- connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
- consult the dealer or an experienced radio/TV technician for help.The device has been evaluated to meet the general RF exposure requirement.The device can be used in portable exposure conditions without restriction.
CANADA-INDUSTRY CANADA (IC)
This radio transmitter has been approved by industry Canada.
This class B digital apparatus complies with Canadian standard ices-003 this device complies with industry Canada license exempt RSS Standard(s).
Operation is subject to the following two conditions.
(1) this device may not cause interference and (2) this device must accept any interference, including interference that may cause undesired operation of the device.
The device has been evaluated to meet the general RF exposure requirement.
The device can be used in portable exposure conditions without restriction.
Bluetooth the woojer vest series 3 qualified design listing was achieved in accordance with the Bluetooth qualification process as specified within the Bluetooth specifications.
CE declaration of conformity we, Woojer LTD., Declare under our sole responsibility, that this Woojer Vest Series 3 product is in conformity with the standards and other normative documents.