Halloween flash sale

20% OFF

Three days only.

00Days
00Hours
00Min
00Sec

Vest 4S User Manual

Woojer Vest 4S

WJRV4SBHNV-101

Your Woojer Vest

Front View

  • 1Control unit / Front-left transducer
  • 2Front-right transducer
Vest 4S front view, labeled 1 and 2

Rear View

  • 3Back-left transducer
  • 4Back-right transducer
  • 5Charging port
  • 6Chair / hanging notch
Vest 4S rear view, labeled 3 to 6

Control Panel

  • 7Power / Bluetooth button
  • 8LED indicator
  • 9Volume up button
  • 10Volume down button
  • 11Sensation up button
  • 12Sensation down button
  • 13Analog audio-in port
  • 14Digital USB-C input port
  • 15Wired headphone jack
Vest 4S control unit, labeled 7 to 15

First Time Usage

Charge Your Vest

USB-C charger connected to the rear charging port, 5V to 20V
The front USB-C port of the control unit, crossed out

Do not use the front USB-C port for charging!

Connect a high power (5V-2A or stronger) USB-C charger to the rear charging port.

Overall charging time depends on your charger's power output.

Connect Your Gear

Console and VR by analog cable, mobile by Bluetooth, PC by USB-C or analog cable

Need help connecting your gear? Get started with our onboarding tool at woojer.com/welcome

Connect Your Headphones

Bluetooth Headphones

Bluetooth headphones and a phone: turn on Bluetooth
Woojer Device Manager app icon

Pair using the Woojer Device Manager app, or a button combination (see Manual Bluetooth Pairing below).


Wired Headphones

If you're using wired headphones, connect them to the headphone jack.

Wired headphones connected to the control unit

Power On/Off

3 seconds long-press on the power buttonVest is on
3 seconds long-press on the power buttonVest is off

Wear Your Vest

All adjusting straps must be loosened before wearing the vest. Make sure to follow these steps in order.

Step 1: adjust the side straps
1Adjust the side straps to fit your body width
Step 2: close and tighten the chest strap
2Close and tighten the chest strap

Fine-Tune Your Experience

  • 1Volume up button
  • 2Volume down button
  • 3Sensation up button
  • 4Sensation down button
Control unit buttons, labeled 1 to 4

Audio-Haptic Sync

Woojer Device Manager app icon

To optimize audio-haptic sync, launch the Woojer Device Manager app.

Manual Bluetooth Pairing

Left half of the ring blinking red and blueBluetooth, hold 5 seconds

Pair with a Bluetooth audio source

With the vest powered off, press and hold the power button for 5 seconds. The left half-ring will blink in alternating red/blue.

On your source device, enter the Bluetooth screen. Locate "Woojer Vest 4S" and pair with it.


Right half of the ring blinking red and blueEarbuds, Bluetooth, hold 5 seconds

Pair with Bluetooth headphones

With the vest powered on, press and hold the power button and the volume up button together for 5 seconds. The right half-ring will blink in alternating red/blue.

Set your headphones to pairing mode and place them near the vest. Both devices should be paired within 30 seconds.

LED Behaviors

  • Bluetooth audio source pairing modeLeft half of the circle blinking red-blue
  • Bluetooth headphones pairing modeRight half of the circle blinking red-blue
  • Searching for audio sourceA running blue light on the left half of the circle
  • Searching for Bluetooth headphonesA running blue light on the right half of the circle
  • Audio source connectedSolid blue light on left half (or user-defined pattern)
  • Headphones connectedSolid blue light on right half (or user-defined pattern)
  • Low batteryCircle blinking red
  • ChargingGradual filling, color changing from red, through orange to green
  • Charging completeFull green

Need help? Get more information at woojer.com/help

Technical Specs

Battery: 11.1V 3500mAh
Charging port: USB-C Power Delivery
Charging power: 5V⎓3A; 9V⎓3A; 15V⎓2A; 20V⎓1.5A
Charging time: 2.5 hours at 20V 1.25A
Haptic freq response: 1-250Hz
Audio freq response: 20-20KHz
Transducer: 4 x Osci V2 TRX
Audio output: Aux 3.5mm TRRS, BT Audio A2DP
Audio input: Aux 3.5mm TRRS, USB-Stereo Audio, BT Audio A2DP
Bluetooth: Bluetooth 5 Audio, BLE App Control and Update
Headphones amp THD: 1%, f = 1 kHz
Headphones out S/N ratio: 98 dB
Headphones amplifier output: 138mW

Warranty

12 months from date of purchase. Learn more about the warranty at woojer.com/warranty